Here's some 'before' shots of the rocker arms and the bottom engine case. I used Pine Sol to clean my parts. It worked great to degrease the parts but If I were to do this again I would take it to a m...

Before and after...

Engine teardown begins! I begin with the top end in this episode. This was probably the most fun I've had so far with the project! It was so cool to see the internal workings of my engine. I learned a...

My Fat Old Lady... Suzuki Bandit 600cc 1998 project....

This is what I came up for turn signal mount. The picture with the tires was me trying to figure if I wanted white walls or not. Its oil markers that we use at my auto shop I work at....

I have been working on my bike over the past two winters and I was done until the stator went out against year so I redid it this winter . I did so much to this bike. It's not perfect and I'm not a pr...

Almost ready to install all of the wirings...

Almost all the wiring to the m-unit is done...

1st time i rebuilded this bike, now im starting over again with a focus on 100% quality and clean looks...

This is how it looked like when i first bought this one...

I took the frame up to Rob Cloutier of Bullit Custom Cycles to get the frame professionally modded. The goal was to fab a rear seat hoop and an electronics tray to fit all my goodies under the seat. W...

Here I dismantled the frong hub from the speedo drive then get the parts ready to be degreased. After degreasing comes sanding, then the buffing process begins! After 3 stages of buffing a brilliant s...

In this episode I took the angle grinder to the frame to cut off some of the tabs and such that I knew I wouldn't need anymore. I will be modding the frame to fit a different seat so it needs to be cl...

Finally finished the teardown by this point. I took a lot of pictures for reference so I can remember how to put things back the way they came. I also needed a lot of photos of the rear end so I can g...

I had stripped a screw on one of the side covers and needed to drill into it. It's getting closer to being completely in pieces....

Teardown took several sessions in the garage! There are a lot of little pieces and things that need to come apart, but again it was cool to see how everything worked....

This is the very beginning of my motorcycle building project! From when I first went to check out and purchase the 1973 CB350G from the PO (purchase owner) in September 2014. I snuggled it into the ga...

* Disks....

At first glance at the Ducati Monster 600cc 2000 as a donor for the construction of the next custom, involuntarily the question arises - what can be done with it? It is stylistically self-sufficient, ...