Should make it sound pretty damn good...

We are still missing 2 parts to fit the flatside CR carbs... I ordered it and I will get them in August... I'll have to wait for a long time unfortunately! I will fit a normal ZXR carb wainting for my...

Airbox was a pin in the arse to remove but once out it freed up a lot of space for my Denali Soundbomb, took her out for a quick black just to check everything was how it should be & I must say she so...

Added a nose cone, I think it finishes off the body work nicely. now, if the bloody weather would play ball I could get that front wheel done !!...

This is how it looked before i started taking it apart, it had all kinds of technology from the 80s, and the weight was about 400kg...

My Ninja 1000. Added vinyl custom made by AMR Racing, wrapped the wheels with vinyl, added CustomTaylor33 high intensity reflective. Zombie Response Team theme...

Once the plan was hatched I started looking for a donor bike and found a 2014 300 Ninja with ABS in short order....

Having my wheels with the tires I did a hastily reassemble them on the frame....

So this mechanical speedometer just 440 LTD ... it is mounted on the left, and must be integrated into the wheel of the Z400 to be mounted right ......

On this disc the four bolt holes that are seen on the central ring do not match the four threaded locations of the new wheel hub.It is played with 1 mm but enough to make it impossible mounting such....

The spoked front wheel is less damaged than the back ....

All Kawasaki Z400 since 1974 are to drive by chain and all KZ 440 since 1980, except for LTD model that it's belt....

As I said, intro, I did not keep the original spoke wheels but put the Z400 model spoked wheels. The rear wheel that I bought secondhand really was tarnished and pitted by rust....

Most of the work on the frame to a close. To continue the transformations, first thing to do, put the engine in place. Once again I am using hoist without which even two people work really would be tr...

Again I decided Gland my rear cradle connector. I twist (sand and torch) a 20mm diameter tube and verify that the resulting angle is right....

As I said, for such a basic bike, onboard power is impressive. Much of it is hidden away beneath the container, but the rest, the rest was located under the seat, around a large battery box behind the...

For my scrambler Kawasaki 440 I want a flat saddle , slightly raised at the back and curved loop width that is slightly narrower front....

For air filters are visible I must extend the big central tube on top of the engine cradle. I'll weld it an extension of at least 120-130 mm. The tube is 40mm in diameter. Whenever feasible I decide t...

The two bent tubes that connect the big hit the top of the cradle does not allow me to highlight the cone air filters in my project....

It was not until September 2016 that I attack seriously the continuous transformation of work and I begins with the frame....