I have been working on my bike over the past two winters and I was done until the stator went out against year so I redid it this winter . I did so much to this bike. It's not perfect and I'm not a pr...

Airbox was a pin in the arse to remove but once out it freed up a lot of space for my Denali Soundbomb, took her out for a quick black just to check everything was how it should be & I must say she so...

Please comment out for the best dress for my buddy!...

Looking for basic tune ups I should keep up with or potential upgrades...

The fuel tank on both bikes came from an early (1980's?????) Honda CG125 Which will require a small amount of work underneath on the tap side in order for the tank to sit down enough to get it level w...

Looks way better with a new gas tank on...

After receiving so many enquiries about the building of these bikes i have finally got round to going through step by step on the whole process....

Just put the new tail tidy on, goes well with the indicators. Few kms and stone chips now....

Added a nose cone, I think it finishes off the body work nicely. now, if the bloody weather would play ball I could get that front wheel done !!...

A true vmax lover. More to see on my facebook.com/vmax1700...

Almost ready to install all of the wirings...

Almost all the wiring to the m-unit is done...

The speedometer is looking dope...

This...

This is how it looked before i started taking it apart, it had all kinds of technology from the 80s, and the weight was about 400kg...

1st time i rebuilded this bike, now im starting over again with a focus on 100% quality and clean looks...

This is how it looked like when i first bought this one...

Soon she will be iceroadracingbike ?...

I took the frame up to Rob Cloutier of Bullit Custom Cycles to get the frame professionally modded. The goal was to fab a rear seat hoop and an electronics tray to fit all my goodies under the seat. W...

Here I dismantled the frong hub from the speedo drive then get the parts ready to be degreased. After degreasing comes sanding, then the buffing process begins! After 3 stages of buffing a brilliant s...